Skip to content

Drain Jetting Medowie

Drain jetting in Medowie scours blocked pipes clean with high-pressure water instead of just poking a hole through the blockage. The jetter strips roots, grease, silt and scale off the pipe walls and washes the debris out. Ring (02) 4063 1093 and the job is quoted before any work starts.

Where it fits. Jetting is one tool in our blocked drains service, and your plumber in Medowie chooses it when the pipe walls need cleaning, not just a hole punched through.

Licensed plumbers and gas fitters · NSW Lic. 359278C

Last updated September 2026

Plumber working at the hose reels on the back of the ute

When Is the Jetter the Right Tool?

A hand rod punches through the blockage and leaves the rest where it sits. Pressurised water cleans the pipe itself. That difference matters most when the same line has blocked more than once.

Repeat blockages

Roots and grease left on the pipe walls catch the next lot of debris within weeks. The jet strips the walls back to the pipe surface.

Root masses

Fine root hair from eucalypts and melaleucas mats inside the pipe. The jet cuts it back and washes it out entirely.

Silt and sand

Sandy local soil washes in through broken pipes and pits, and the pipe silts up from underneath. Water pressure is the only practical way to move that volume.

Long runs

On the acreage blocks, the hose travels the whole line from one access point, so a run under the yard is cleared without digging a single hole.

No chemicals are involved, so the water pushed through ends up in the sewer or stormwater system exactly as it went in.

Four Steps to a Clean Pipe

  1. 01

    Find the access point

    We locate the inspection opening or remove a fixture, and confirm which line is blocked before water goes anywhere near it.

  2. 02

    Camera first where it matters

    If the cause is unclear, a CCTV drain inspection runs ahead of the jetter so we know whether we are cutting roots, breaking up grease or flushing silt.

  3. 03

    Jet the line

    The nozzle works from the far end back toward the opening, cutting and flushing in one pass until water runs clear.

  4. 04

    Prove it

    A second camera check confirms the line is clean end to end before we pack up, so you are not taking the result on faith.

That last step is the standard on every clear we do: footage before and after, so you see the cause and then the clean pipe.

What Decides the Cost of Jetting?

Jetting cost starts with how easily the jetter hose can get into the line:

  • Access A clear inspection opening is a quick start. A buried or concrete-covered cap adds time before the jetter even runs.
  • Line length and material Older earthenware on the pre-1980s blocks takes a gentler, slower pass than modern PVC.
  • What is in the pipe Soft kitchen grease flushes out in one pass, while a matted root clump gets cut back layer by layer.
  • When you need us It costs nothing to get us out to your door (excluding after-hours).

When the Jetter Isn't the Fix

When we're not the right call: a collapsed or crushed pipe cannot be cleared by water pressure, because there is no pipe left to clear. If the camera shows structural damage, we quote the repair honestly rather than jet a lost cause.

A choke in the sewer main out past your boundary is the water authority's to clear, and no private jetter should go into their main.

Plumber working a drain-clearing machine

Why Local Lines Keep Reblocking

The roots come first

Blocks that back onto conservation bushland sit next to mature eucalypts, and their fine roots hunt out any gap in the older earthenware joints. Sandy soil then washes into the same defect, so the pipe silts from underneath while the roots keep growing in from the sides.

The ground does the rest

The town sits barely above the wetland country around it, Moffats Swamp Nature Reserve included, and groundwater stays shallow over much of it. A line that is only partly choked limps along through dry spells, then closes completely once steady rain arrives. Long-run rainfall averages 1,139 millimetres a year, so those steady spells are not rare.

That is why we treat jetting as a reset rather than a bandaid: clean the whole pipe, film it, and tell you honestly whether the line needs pipe relining or tree root removal to stay clear.

Plumber pulling fittings from the ute drawers

Drain Jetting Questions From Local Homes

Will jetting damage old earthenware pipes?

No. Pressure is set to match the pipe material, so older earthenware gets a gentler pass that strips roots and silt while leaving sound pipe intact. Where a section is cracked or collapsed, the camera picks it up first and the repair is quoted as its own job.

Do you jet the long lines on acreage blocks?

Yes. Long runs are where the jetter pays for itself, because the hose follows the whole pipe from a single opening. We carry enough hose and water for acreage properties, and the figure is fixed before anything starts.

How often should a drain be jetted preventatively?

No set interval applies. Where eucalypt roots have opened a joint, an annual jet keeps the line moving between bigger repairs. After a relining or rebuild, the root entry point is gone and routine jetting generally becomes unnecessary.

Does jetting clear stormwater lines as well as sewer lines?

Yes. Lines choked with sand and leaf litter clear well under pressure, and silted stormwater is a regular find on ground this flat and damp. If the pipe needs rebuilding rather than clearing, relining is the usual next step.

Get the Jetter Booked In

Call (02) 4063 1093 or send the form below. Available 24/7, you see a fixed figure ahead of any work, and every job carries our 365-day warranty on all work.

Call (02) 4063 1093

Request a callback

Leave a name and number and a plumber will ring you back.

We use your details only to call you back about this job. See our privacy policy.

Call (02) 4063 1093 Get a quote